How Can We Help You?

Featured Article

How to Get Started with ECS Solutions

1. Step 1: Initial contactGet in touch through the contact page with an outline of what you need: the site, the process, the approximate load and the timescale. You do not need a finished specification at this stage. A clear description of the problem is enough to start.
2. Step 2: Site assessmentAn ECS engineer visits the facility to see the existing installation, confirm the supply arrangement and understand the operating constraints. This visit is where most of the real requirements surface, particularly the ones that never make it into a written brief.
3. Step 3: Design and proposalYou receive a technical proposal with single line diagrams, panel schedules, a compliance statement against the applicable standards, and a priced scope. Review it with your operations team as well as your engineers, since the operating detail is easiest to change at this point.
4. Step 4: Manufacturing and factory testingPanels are built and routine tested in the ECS facility. You are welcome to attend the factory acceptance test, and doing so is worth the time. Faults found on the factory floor cost a fraction of the same fault found on site.
5. Step 5: Installation and commissioningCertified technicians install, terminate and commission the system, then hand over test records, as built drawings and the configuration backup. Operator and maintenance training is arranged as part of handover.